Aetna Group's RoboPac RoboPlat-LPA

Low profile wrapping turntable with automatic-pneumatic clamp and cutting device. Rotoplat LP-A represents the innovative and flexible solution to fully automatic pallet wrapping. The innovative film clamp and cutting unit ensures film hooking and cutting in any operating conditions. The pallent can be positioned by fork lift truck or pallet jack and, thanks to the base plate 92 mm. high, Rotoplat LP-A has a high operating flexibility.

Rotation speed adjustable from panel board with acceleration and deceleration controlled by inverter Phase stopping point (+/- 20 mm) Load height sensing photocell Up/down spool carriage speed adjustment by frequency changer Control board by microprocessor with digital push buttons for adjustment and selection of load wrapping parameters 400 V. 3 Ph + N - 50/60 Hz

Bottom wraps number Top wraps number Table rotation speed Spool carriage speed Photocell sensingdelay

Film tension (306) Pre-stretch ratio (406-506-706) Force to the load adjustable during 4 phases of wrapping cycle: bottom, top, up, down (506-706)

Cycles selectable from control panel: Full wrapping (up & down) Top sheet wrapping cycle Cycle with reinforcement wraps Memorization of 8 working cycles and selectable from panel Top platen wrapping cycle (option)

Plate diameter 1800 mm. for loads  1200x1200 mm.( not for trans-pallet) Ramp for 1650 mm. plate diameter Ramp for 1800 mm. plate diameter Mast for loads 2800 mm. high Mast for loads 3100 mm. high Pneumatic top platen for loads 2400 mm. high Pneumatic top platen for loads 2800 mm. high Pneumatic top platen for loads 3100 mm. high