• Edgebanding thickness: .4mm - 3mm (.016-1/8”)
• Guillotine capacity: 1.2mm
• Feed speed: 30 ft/min.
• Panel height: 3/8” min – 1 9/16” max
• Minimum panel length: 5 1/2”
• Minimum panel width: 2 3/8”
• Minimum distance between panels: 22”

• High Frequency Motors
• Single Phase ONLY
• Semi Automatic Magazine
• Quick Disconnect / Change Motors
• Mechanical Digital Readouts for the Positioning of the Top/Bottom Trimmers
• Mechanical Digital Readout for the Height of the Pressure Beam
• Adjustable Side Support
• Replaceable Track Pads
• Equipped with Conical (12 degree bevel) Cutters
• Digital Inverter for Electronic Motor Braking
• Castors Mounted to Machine Base for Easy Movement
• Centralized Dust Extraction

Machine Specs:

Glue Pot Unit:

Heating Time

Approx. 8-10 min.

Glue Capacity

2.2 lbs.

End Cutting Trimming Station:

Horsepower

.30 HP

RPM

12,000 RPM

Edge Trimming Unit:

Horsepower

.70 HP

RPM

12,000 RPM

Conical Cutter

12 degree bevel

Feed Motor Horsepower

1 HP

Feed Speed

30 FPM

Frequency Converter

200 Hz

Dust Hood Diameter

120mm

Pneumatic Operating Pressure

90 PSI

More Features:

The machine base is made of a tubular steel structure and is designed to assure maximum stability and accuracy.

All operating units raise and lower simultaneously when the pressure beam is adjusted. No adjustment is required for the glue roller when changing panel thickness. The pressure beam has digital height indicators and a single row of pressure rollers with steel bearings.

Teflon coated glue pot to facilitate glue changeover. Warm up time is approximately eight to ten minutes. The unit is also equipped with a quick disconnect plug for changing from one pot to another.

There are a total of two pressure rollers for pressing the banding to the workpiece edge. The first roller is powered and applies pressure mechanically. It is also Teflon coated to prevent the banding material from slipping. The idle roller is perpendicular to provide extra pressure along the top and bottom edge. The machine comes equipped with a semi-automatic strip magazine.

This unit is composed of one independent .30 hp motor and a double blade cutting system. End trim utilizes a 90-degree cut on the leading and trailing edge of the panel. Blade alignment with reference to the cutting point has been redesigned to ensure a precise and consistent cut.

All working units are enclosed under an acoustical safety hood to reduce noise and prevent accidents. The hood has a safety microswitch which prevents the machine from operating when the hood is open.

Click here to watch SCM Videos