The buffing unit has two .25 hp motors. It can also be tilted up to 12 degrees to provide a softer, more refined edge finish.

• Edgebanding thickness: .4mm - 8mm (.016-5/16”)
• Guillotine capacity: 3mm
• Feed speed: 36 ft/min.
• Panel height: 3/8” min – 2 1/8” max
• Minimum panel length: 5 1/2”
• Minimum panel width: 2 3/8”
• Minimum distance between panels: 20”

Machine Specs:

Glue Pot Unit:

     Heating Time

Approx. 8-10 min.

     Glue Capacity

1.5 liters

End Cutting Trimming Station:

     Horsepower

.5 HP

     RPM

12,000 RPM

     Tilting

Two Preset Positions

Edge Trimming Unit:

     Horsepower

.7 HP

     RPM

12,000 RPM

     Tilting

0-25 degrees

     Cutting Tools

Straight, 3mm radius cutters

Buffing Unit

     Horsepower

.25 HP

     RPM

2,800 RPM

     Diameter/Bore

152mm/17mm

Other Specs

Feed Motor Horsepower

2 HP

Feed Speed

36 FPM

Frequency Converter

200 Hz

Dust Hood Diameter

Per Drawing

Pneumatic Operating Pressure

90 PSI

More Features:

The machine base is made of a tubular steel structure and is designed to assure maximum stability and accuracy.

All operating units raise and lower simultaneously when the pressure beam is adjusted. No adjustment is required for the glue roller when changing panel thickness. The pressure beam has digital height indicators and a single row of pressure rollers with steel bearings.

Teflon coated glue pot to facilitate glue changeover. Warm up time is approximately eight to ten minutes. The unit is also equipped with a quick disconnect plug for changing from one pot to another.

There are a total of three pressure rollers for pressing the banding to the workpiece edge. The first roller is powered and applies pressure pneumatically. It is also Teflon coated to prevent the banding material from slipping. The two idle rollers have opposing one-degree tilt to provide extra pressure along the top and bottom edge. These rollers also have independent pneumatic adjustment. The machine comes standard with an automatic strip magazine.

This unit is composed of two independent .50 hp motors mounted on THK guides. End trim utilizes a draw cut system for reduced blade projection on thick panels. The unit comes standard with automatic tilting of the unit from the control panel with two preset positions.

This unit is composed of two independent .7 hp motors operating at 12,000 rpm. The unit is capable of tilting 0-25 degrees. It comes with top and bottom copy wheels which will not damage soft materials (i.e., veneer, metallic edge, etc.). The motors have quick release plugs to facilitate tooling changes and mechanical digital readouts for positioning.

All working units are enclosed under an acoustical safety hood to reduce noise and prevent accidents. The hood has a safety microswitch which prevents the machine from operating when the hood is open.

Click here to watch SCM Videos