General Features:
• Rubber coated pressing rollers before and after working unit
• 1 HP Inverter variable speed feed unit. Feed speeds set at 10 to 60 feet per minute
• Y-Delta two-stage reduced voltage starter on main motor
• 2 roller Infeed and outfeed table extensions
• Automatic Electronic Table Positioning Device
• Adjustable sanding drum and pad position for micro precision adjustment
• Electronic digital thickness readout of work table position
• Powered table lifting by means of four heavy duty motor and lifting columns double fastened at both top and bottom of the lifting columns to provide exceptional table stability
• Electronic tracking of abrasive belt
• Automatic feed mat tracking
• Pneumatic belt tensioning with center fulcrum to compensate for tapering of abrasive belt
• Front and rear emergency stop buttons
• Automatic emergency stop of machine for:
• sanding belt breaking, tensioning, over tracking
• opening of the access door to the operating groups
• absence of compressed air
• overload on main motors
• Amperage meter for main motors allows maximum utilization of available horsepower
• Main disconnect switch with the ability to be locked out by padlock
• In feed flexible steel hold down, and anti-kick back plate
• 50 shore, negative profile (waffle style) rubber feed mat
• LOGIC 50 K Electronic Programmer for timing/anti-dubbing of the pad
• Rubber coated pressing rollers before and after working unit
• 1 HP Inverter variable speed feed unit. Feed speeds set at 10 to 60 feet per minute
• Y-Delta two-stage reduced voltage starter on main motor
• 2 roller Infeed and outfeed table extensions
• Automatic Electronic Table Positioning Device
• Adjustable sanding drum and pad position for micro precision adjustment
• Electronic digital thickness readout of work table position
• Powered table lifting by means of four heavy duty motor and lifting columns double fastened at both top and bottom of the lifting columns to provide exceptional table stability
• Electronic tracking of abrasive belt
• Automatic feed mat tracking
• Pneumatic belt tensioning with center fulcrum to compensate for tapering of abrasive belt
• Front and rear emergency stop buttons
• Automatic emergency stop of machine for:
• sanding belt breaking, tensioning, over tracking
• opening of the access door to the operating groups
• absence of compressed air
• overload on main motors
• Amperage meter for main motors allows maximum utilization of available horsepower
• Main disconnect switch with the ability to be locked out by padlock
• In feed flexible steel hold down, and anti-kick back plate
• 50 shore, negative profile (waffle style) rubber feed mat
• LOGIC 50 K Electronic Programmer for timing/anti-dubbing of the pad