Doucet XPRS-24 24" Return Conveyor for Edgebanders

The Doucet XPRS Return is specially designed for use with smaller edgebanders, Its low cost and tiny footprint make it perfect choice for small to medium size cabinet makers. At last an Edgebander Return that will carry your business to a higher level of profitability.

• Available in left or right hand return configuration
• Feature 24 inches wide receiving modules and return conveyors
• Standard module length is 60 inches, return length is proportionate to the length of your edgebander.
• Power requirement is 110 volts - single phase - 15 amps service, no compressed air is required
• PVC Rollers are individually driven by welded urethane belts 

Operating Principle

1. Feed rollers, driven by a variable speed motor, from 0 to 40 ft/min, guide the part onto the receiving module.  
2.  A set of top rollers prevent larger panels from tipping down while entering the receiving module.
3. Polymer belts side shift the panels to the return rollers quickly and efficiently.
4. The return rollers are 2 inches lower than the pass height of the edgebander, so parts can travel in opposite directions without interference.
5. The transfer process occurs on a continuous basis.