The Ideal MH-4 ( Half Lap Machine ) is a specially designed machine for the production of Half-Lap Joints in Wood, Vinyl and Aluminum, for the use in SDL and TDL bars, window grills, and decretive cabinetry. Using Half-Lap joints, instead of individually mitered pieces results in a stronger and esthetically pleasing assembly. The Half-Lap joint consists of two parts. The vertical and horizontal pieces, which are, Half-Lapped, to produce the interlocking joint. Since the cut is the same regardless of profiles tooling and changeover cost is reduced. Special machine configurations are available on request, including NC positioning systems and cut list downloads.
The MH-4 is equipped with 2 top and bottom milling cutters, and a front and rear dado set. By utilizing a front and rear dado, the vertical and horizontal members can be worked from the front and back without the need of counter profile blocks or, rotating the parts. Parts off the machine are tear out free and ready for assembly.
Technical Specifications:
Motors: 3 @ 1.1kw ( 1.5 hp) ea.
Voltage: 220-480.
RPM: 6200 rpm @ 60 hz.
Air: 6 bar ( 85 psi).
Tooling: Insert Carbide.
Dado: 200 mm (7.875”).
Profile: 140 mm (5.500”).
Min Profile:
Wide: ¼”.
High:¼”.
Max. Profile .
Wide: 1.5 “.
High: 1.5 “.
Dust Collection: 6” dia.
Cycle Time: 4-6 seconds.
(tooling not included).
The MH-4 is equipped with 2 top and bottom milling cutters, and a front and rear dado set. By utilizing a front and rear dado, the vertical and horizontal members can be worked from the front and back without the need of counter profile blocks or, rotating the parts. Parts off the machine are tear out free and ready for assembly.
Technical Specifications:
Motors: 3 @ 1.1kw ( 1.5 hp) ea.
Voltage: 220-480.
RPM: 6200 rpm @ 60 hz.
Air: 6 bar ( 85 psi).
Tooling: Insert Carbide.
Dado: 200 mm (7.875”).
Profile: 140 mm (5.500”).
Min Profile:
Wide: ¼”.
High:¼”.
Max. Profile .
Wide: 1.5 “.
High: 1.5 “.
Dust Collection: 6” dia.
Cycle Time: 4-6 seconds.
(tooling not included).