DMC sd 90 KRCS 135 Automatic Wide Belt Planer Sander.
MAIN FEATURES
LONG BELTS: 2.620 MM LENGTH FOR GREATER FINISHING AND PRODUCTIVITY.
PHOTOCELLS WITH “PRESENCE DETECTION SYSTEM” TO ENSURE ALWAYS THE CORRECT CENTERING OF THE ABRASIVE BELT.
FLOATING PRESSURE ROLLERS: PRECISE AND CORRECT WORKPIECES HOLDING IN ALL WORKING CONDITIONS.
TECHNICAL DATA
working width mm 1.350
min/max. working thickness mm 4 ÷ 200
sanding belt width mm 1.370
sanding belt length mm 2.620
GENERAL FEATURES
Base and working table
Steel structure with electric cabinet on the machine front
Sanding belts introduction from the machine left side
Powered adjustment of working thickness
Main motor positioned inside the base
Electrical equipment
Electromechanical keyboard positioned on the machine front side
Automatic star-delta start of the main motor
Overload protections on the motors
Motors in isolation class IP54
Emergency and safety devices
Automatic brake for rapid shutdown of the operating group
Hand-safety emergency device in the infeed panel area
Front and rear emergency pushbutton
Padlockable main switch
Safety micro for overthickness
Automatic emergency stop machine for:
Sanding belt breaking
Not-tensioned sanding belt
Lateral outplacement of sanding belt
Absence of compressed air
Overload on main motor
BASIC MACHINES STANDARD EQUIPMENT
Electronic ammeter on main motor for readout of absorbed power
Electronic readout of working thickness
Electronic oscillating of sanding belts
Rubber-coated pressure rollers
Infeed anti-kickback vertically pivoted roller on 1st operating group
60 Sh rubber feed belt
Infeed/outfeed workpieces support rollers with two rollers
Automatic device for feed belt tracking and tensioning
MAIN FEATURES
LONG BELTS: 2.620 MM LENGTH FOR GREATER FINISHING AND PRODUCTIVITY.
PHOTOCELLS WITH “PRESENCE DETECTION SYSTEM” TO ENSURE ALWAYS THE CORRECT CENTERING OF THE ABRASIVE BELT.
FLOATING PRESSURE ROLLERS: PRECISE AND CORRECT WORKPIECES HOLDING IN ALL WORKING CONDITIONS.
TECHNICAL DATA
working width mm 1.350
min/max. working thickness mm 4 ÷ 200
sanding belt width mm 1.370
sanding belt length mm 2.620
GENERAL FEATURES
Base and working table
Steel structure with electric cabinet on the machine front
Sanding belts introduction from the machine left side
Powered adjustment of working thickness
Main motor positioned inside the base
Electrical equipment
Electromechanical keyboard positioned on the machine front side
Automatic star-delta start of the main motor
Overload protections on the motors
Motors in isolation class IP54
Emergency and safety devices
Automatic brake for rapid shutdown of the operating group
Hand-safety emergency device in the infeed panel area
Front and rear emergency pushbutton
Padlockable main switch
Safety micro for overthickness
Automatic emergency stop machine for:
Sanding belt breaking
Not-tensioned sanding belt
Lateral outplacement of sanding belt
Absence of compressed air
Overload on main motor
BASIC MACHINES STANDARD EQUIPMENT
Electronic ammeter on main motor for readout of absorbed power
Electronic readout of working thickness
Electronic oscillating of sanding belts
Rubber-coated pressure rollers
Infeed anti-kickback vertically pivoted roller on 1st operating group
60 Sh rubber feed belt
Infeed/outfeed workpieces support rollers with two rollers
Automatic device for feed belt tracking and tensioning