Used Northtech NT-660HC-LINESHAFT READY.
Northtech NT-660HC
Lineshaft conversion completed, All shafts, pulleys gear reducers and clutches hooked up.
Some spare bearings, clutch cables, carbide inserts and screws included.
New Carbide inserts recently installed, 3 sides have never been run.
• 26" Single Side Production series Planer,
• table positioning system powered by lineshaft with gear box activated by hand lever.
• helical cutterhead,
• 14 x 14 x 2mm 4-sided solid carbide inserts,
• CFM requirements 2,600.
• Table area 40" x 27"
• Cutterhead diameter 4"
• Two sectional infeed rollers (2" sections), 3" diameter
• Three steel bed rollers
Northtech NT-660HC
Lineshaft conversion completed, All shafts, pulleys gear reducers and clutches hooked up.
Some spare bearings, clutch cables, carbide inserts and screws included.
New Carbide inserts recently installed, 3 sides have never been run.
• 26" Single Side Production series Planer,
• table positioning system powered by lineshaft with gear box activated by hand lever.
• helical cutterhead,
• 14 x 14 x 2mm 4-sided solid carbide inserts,
• CFM requirements 2,600.
• Table area 40" x 27"
• Cutterhead diameter 4"
• Two sectional infeed rollers (2" sections), 3" diameter
• Three steel bed rollers