Machine Standard Features
1st Head Roller
2nd Head Combo Platen
Grooved rubber coated pressing rollers before and after working unit
2HP variable speed feed motor 3.5-18 m/min (12-60 FPM)
Y-Delta two-stage reduced voltage starter on main motor
Automatic Electronic Table Positioning Device
In-feed / Out-feed extended tables for easier part feeding
Pneumatic On/Off selector of both rollers and pad
Adjustable sanding drum and pad position for micro precision adjustment
Electronic digital thickness readout of work table position
Powered table lifting by means of four heavy duty motor and lifting columns double fastened at both top and bottom of the lifting columns to provide exceptional table stability
Electronic tracking of abrasive belt
Pneumatic belt tensioning with center fulcrum to compensate for tapering of abrasive belt
Front and rear emergency stop button
Amperage meter for main motors allows maximum utilization of available horsepower
Main disconnect switch with the ability to be locked out by padlock
In feed flexible steel hold down, and anti-kickback plate
50 shore, negative profile (waffle style) rubber feed mat
LOGIC 50 K Electronic Programmer for timing/anti-dubbing of the pad
1st Head Roller
2nd Head Combo Platen
Grooved rubber coated pressing rollers before and after working unit
2HP variable speed feed motor 3.5-18 m/min (12-60 FPM)
Y-Delta two-stage reduced voltage starter on main motor
Automatic Electronic Table Positioning Device
In-feed / Out-feed extended tables for easier part feeding
Pneumatic On/Off selector of both rollers and pad
Adjustable sanding drum and pad position for micro precision adjustment
Electronic digital thickness readout of work table position
Powered table lifting by means of four heavy duty motor and lifting columns double fastened at both top and bottom of the lifting columns to provide exceptional table stability
Electronic tracking of abrasive belt
Pneumatic belt tensioning with center fulcrum to compensate for tapering of abrasive belt
Front and rear emergency stop button
Amperage meter for main motors allows maximum utilization of available horsepower
Main disconnect switch with the ability to be locked out by padlock
In feed flexible steel hold down, and anti-kickback plate
50 shore, negative profile (waffle style) rubber feed mat
LOGIC 50 K Electronic Programmer for timing/anti-dubbing of the pad
| Working Width | 53" (1,350 mm) |
| Number of Heads Available | 2 |
| Feed Motor | 2 HP with inverter |
| Feed Speed | 12 to 60 fpm |
| Maximum Work piece Thickness | 6.69" (170 mm) |
| Minimum Work piece Length | 12.5" |
| Abrasive Belt Size | 53" x 85" |
| Compressed Air Requirements | 6 Bar (88 PSI) |
| Dust Outlets | 2 outlets @ 7.75" (195 mm) |
| Exhaust Requirements | 3,544 CFM |
| Power Requirements | 150 amps @ 230 Volts/3 phase |